Well I finally finished my D3 and I have to be honest I'm actually very impressed with this car. I have some more work to do to get it 100% but its all just shimming out slop and getting it where I want it to be.
I do have one issue, I'm running the wide angle CVD's and I'm still getting chatter at full lock, what could be causing this? I took them both out cleaned and re greased them and they still seem to have a bit of binding which is not acceptable. My next idea is to take the set screws out of the rollers and use some heat shrink to keep the pins in so everything can move as free as possible, has anyone done this?
Also does anyone have have a decent starting setup?
right now its
Front:
Orange kit springs
2 hole
35wt
Rear:
White kit spring
3 hole
22.5wt
(This post was last modified: 02-13-2014, 05:40 PM by C.Raynes.)
I do have one issue, I'm running the wide angle CVD's and I'm still getting chatter at full lock, what could be causing this? I took them both out cleaned and re greased them and they still seem to have a bit of binding which is not acceptable. My next idea is to take the set screws out of the rollers and use some heat shrink to keep the pins in so everything can move as free as possible, has anyone done this?
Also does anyone have have a decent starting setup?
right now its
Front:
Orange kit springs
2 hole
35wt
Rear:
White kit spring
3 hole
22.5wt