Hello Guest, if you are reading this, it means you are not registered on our board. Click here to register for a user account and with a few simple steps, you will be able to enjoy all the features! Along with access to special contests only available to our community members.

Post Reply 
OTA R31 CS Setup
11-14-2012, 11:03 PM (This post was last modified: 11-15-2012 07:56 PM by EG_CIVIC.)
Post: #1
OTA R31 CS Setup
   
   
   

This is my OTA-R31 (H2 Riku Version) :P Enjoy!!

RC Drift Chassis Information
Manufacturer: Street Jam
Model: OTA-R31
Track Surface: Asphalt
Tires:Streetjam 014
Motor and ESC: Hobbywing V2.1 120A, Speedpassion V3 8.5R
Servo: Futaba 9551

Chassis Settings
Front Setup
Camber (Degrees) (Positive is out, Negative is in): -5deg (by eyes measure)
Toe (Degrees) (Specify Toe in or out): 0deg
Caster angle (Degrees): ~ 18deg
Sway Bar (yes/no): No
Ride Height (mm): ~5mm
Springs (indicate type, length, hardness, etc): Front Yokomo Blue Soft
Damper Oil (indicate weight or #): Trinity 20
Upper Damper Position (Lower # indicates inner most position): 5
Lower Damper Position (Lower # indicates inner most position): 1
Others:
- Yokomo SD Upper Arm
- Yokomo SD Lower Arm
- Eagle Racing Turn Knuckle (Custom)
- Mono Center Suspension

   

Rear Setup
Camber (Degrees) (Positive is out, Negative is in): -1deg
Toe (Degrees) (Specify Toe in or out): .5deg in
Sway Bar (yes/no): No
Ride Height (mm): ~5mm
Springs (indicate type, length, hardness, etc): StreetJam Red Soft
Damper Oil (indicate weight or #): Trinity 20
Upper Damper Position (Lower # indicates inner most position): Outer
Lower Damper Position (Lower # indicates inner most position): Outer
Other :
- Mono Center Suspension

Drivetrain
Front Belt (mm or teeth): 174
Mid Belt:(mm or teeth):420
Rear Belt (mm or teeth): 177
Front Pulley (teeth and differential type): 37T One-way
Front Center Pulley (teeth and differential type): 13T
Mid Front Pulley (teeth and differential type):18T
Mid Rear Pulley (teeth and differential type):18T
Rear Center Pulley (teeth and differential type): 20T
Rear Pulley (teeth and differential type): 36T Spool

Gearing
Spur (teeth and pitch): 114T 64P
Pinion (teeth and pitch): 25T 64P
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)
Yokomo RC Drift Bodies Tamiya RC Drift Products Yokomo Products