Hello,
Just posting for your information here.
I ordered these from hobby best on eBay for my FS-01D. It states in there that it's for use with MS, FS, FXX and so on. Just about all chassis.
However, while the bearing that goes in from the inside fits fine. The outer bearing is too small. It requires a 5x11 bearing
The one that goes into the stock knuckle is 5x10.
So if you end up ordering these knuckles for your FS-01D make sure you also order bearing for it. Hobbybest also sells the bearings from MST so that should do the trick.
I just ordered them, I will update here once I get them and install them.
Here is a photo of how loose the stock bearing fits
Just posting for your information here.
I ordered these from hobby best on eBay for my FS-01D. It states in there that it's for use with MS, FS, FXX and so on. Just about all chassis.
However, while the bearing that goes in from the inside fits fine. The outer bearing is too small. It requires a 5x11 bearing
The one that goes into the stock knuckle is 5x10.
So if you end up ordering these knuckles for your FS-01D make sure you also order bearing for it. Hobbybest also sells the bearings from MST so that should do the trick.
I just ordered them, I will update here once I get them and install them.
Here is a photo of how loose the stock bearing fits
MST FS-01D >>> 2.00 CS
HPI Sprint 2 >>> 1.58 CS
(This post was last modified: 08-06-2014, 01:18 AM by Rusty180SX.)
HPI Sprint 2 >>> 1.58 CS