OTA R31 CS Setup

0 Replies, 7538 Views

   
   
   

This is my OTA-R31 (H2 Riku Version) Tongue Enjoy!!

RC Drift Chassis Information
Manufacturer: Street Jam
Model: OTA-R31
Track Surface: Asphalt
Tires:Streetjam 014
Motor and ESC: Hobbywing V2.1 120A, Speedpassion V3 8.5R
Servo: Futaba 9551

Chassis Settings
Front Setup
Camber (Degrees) (Positive is out, Negative is in): -5deg (by eyes measure)
Toe (Degrees) (Specify Toe in or out): 0deg
Caster angle (Degrees): ~ 18deg
Sway Bar (yes/no): No
Ride Height (mm): ~5mm
Springs (indicate type, length, hardness, etc): Front Yokomo Blue Soft
Damper Oil (indicate weight or #): Trinity 20
Upper Damper Position (Lower # indicates inner most position): 5
Lower Damper Position (Lower # indicates inner most position): 1
Others:
- Yokomo SD Upper Arm
- Yokomo SD Lower Arm
- Eagle Racing Turn Knuckle (Custom)
- Mono Center Suspension

   

Rear Setup
Camber (Degrees) (Positive is out, Negative is in): -1deg
Toe (Degrees) (Specify Toe in or out): .5deg in
Sway Bar (yes/no): No
Ride Height (mm): ~5mm
Springs (indicate type, length, hardness, etc): StreetJam Red Soft
Damper Oil (indicate weight or #): Trinity 20
Upper Damper Position (Lower # indicates inner most position): Outer
Lower Damper Position (Lower # indicates inner most position): Outer
Other :
- Mono Center Suspension

Drivetrain
Front Belt (mm or teeth): 174
Mid BeltSadmm or teeth):420
Rear Belt (mm or teeth): 177
Front Pulley (teeth and differential type): 37T One-way
Front Center Pulley (teeth and differential type): 13T
Mid Front Pulley (teeth and differential type):18T
Mid Rear Pulley (teeth and differential type):18T
Rear Center Pulley (teeth and differential type): 20T
Rear Pulley (teeth and differential type): 36T Spool

Gearing
Spur (teeth and pitch): 114T 64P
Pinion (teeth and pitch): 25T 64P
(This post was last modified: 11-16-2012, 01:56 AM by EG_CIVIC.)



Users browsing this thread: 1 Guest(s)