RWD Chassis Setup Template

0 Replies, 2264 Views
Thread Closed 

Please post your chassis setup based on the template below, create a thread of your own for your setup.  Post a few pictures to show the features of the chassis.

Chassis introduction:  (Tell everyone about your chassis)

RC Drift Chassis Information
Manufacturer: 
Model: 
Track Surface: 
Motor and ESC: 
Servo: 

Chassis Settings
Front Setup
Camber (Degrees) (Positive is out, Negative is in): 
Toe (Degrees) (Specify Toe in or out): 
Caster (Degrees): 
King Pin Angle (Degrees): 
Kick-up (mm): 
Sway Bar (yes/no): 
Ride Height (mm): 
Springs (indicate type, length, hardness, etc): 
Damper Oil (indicate weight or #): 
Upper Damper Position (Lower # indicates inner most position): 
Lower Damper Position (Lower # indicates inner most position): 
Front Tires (Type): 
Other (Weights, Mods, anything else that can effect performance): 

Rear Setup
Camber (Degrees) (Positive is out, Negative is in): 
Toe (Degrees) (Specify Toe in or out): 
Caster (Degrees): 
Kick-up (mm): 
Sway Bar (yes/no): 
Ride Height (mm): 
Springs (indicate type, length, hardness, etc): 
Damper Oil (indicate weight or #): 
Upper Damper Position (Lower # indicates inner most position): 
Lower Damper Position (Lower # indicates inner most position): 
Rear Tires (Type): 
Other (Weights, Mods, anything else that can effect performance): 

Drivetrain
Rear Drive Ratio: 

Gearing
Spur (teeth and pitch): 
Pinion (teeth and pitch): 

Gyro
Type:
[Image: dmsig02.jpg]
(This post was last modified: 01-01-2016, 07:20 AM by driftmission.)



Users browsing this thread: 1 Guest(s)