Right now I'm using 2 drrs and 18* timing on. Rwd r31 8.5 motor
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Right now I'm using 2 drrs and 18* timing on. Rwd r31 8.5 motor
Sent from my iPhone using Tapatalk
How smooth is SP Reventon S? I'm worried about cogging?
I wouldn't worry about it. I just found out when I did my conversion that my sensor wire was disconnected and my car still ran fine. (Reventon Pro with and Atomik 13.5)
When I see Chiefy707 I just want to yell "AWOO! AWOO! AWOO!" like one of the 300 Spartans.
It's made with bits of real panther, so you know it's good. (02-04-2014, 05:04 PM)lougc8 Wrote:(02-04-2014, 04:52 AM)valve_timing Wrote: What timing and drrs settings does everyone use ? I'm using a Reventon PRO 1.1 and a 13.5t Competition MMM for drift, any recommendations for timing and other settings?
MST MS-01D VIP II
Speed Passion Reventon PRO 1.1 Speed Passion 13.5t v3.0 MMM Savox SG-1258TG Airtronics MT4 w/ TX-461
1st- that's normal, if you want to reverse, you must upgrade ESC.
2nd- there's no need to load drift profile, it's more litlte configure.
I have a Reventon R and 10.5 sensored motor combo. I have the LED card and software running properly.
The problem is that I have no forward. I only have reverse. The reverse is the full throttle that should be for forward. I have swapped the rev on the transmitter, but it just changes it on the transmitter, not the car. I have tried recalibrating the esc countless times. Any ideas? I am out. Thanks!
Check your wire positions
Midwest Slidewayz RC drift club
Chicagoland Toys and Hobbies Hikotech Bianca Eagle Racing Drift Fleet Speed Passion USA Futaba Savox
What Firmware are you running?
Sent from my SM-G900W8 using Tapatalk
MST MS-01D VIP II
Speed Passion Reventon PRO 1.1 Speed Passion 13.5t v3.0 MMM Savox SG-1258TG Airtronics MT4 w/ TX-461
Currently Mod 1. I have tried several others also.
SP says it is my transmitter. However, the transmitter works fine with my Hobbywing. |