WUN FR-D V.3 Conversion-Gearbox

What else do I need to build the rear gearbox for a WUN FR-D V.3 Conversion

I am using a custom chassis so I do not have the Yokomo Drift package.

I have ordered the following parts:
Wrap-Up Next FR-D V3.0 - 7075 Edition (Silver)
Overdose Aluminum Gear Case For Yokomo DPM Black 1:10 RC Car Drift #OD1592
Overdose Aluminum Dual Position Front One-Way Set Yokomo Drift Package #OD1427
Overdose HardSteel Center Cup Joint Yokomo Drift Package 1:10 RC Car #OD1277
Yokomo Center One-Way Shaft (SD-644TS_SALS)
Yokomo Bearing Set for Drift Racer (D-148_SALS)
Yokomo Solid Axle Set (SD-501SAS_SALS)
Yokomo Rear Input Shaft for DRIFT PACKAGE Gear Diff ( D-150IR_SALS
Yokomo Rear Input Shaft (SD-303R_SALS)

Thanks in advance for the advice!

[Piper]

I don't think the Overdose DPM Gear case will work maybe with modification. The Fr-d is RWD meaning one way's are essentially useless. you cannot use the front one way or the center one way because you are not using a front axle. Yokomo Rear Input Shaft for DRIFT PACKAGE Gear Diff I believe is only for use of the actual gear differential itself which is not on this list, unless you plan on getting one in the future you won't need this part. You will need bearings and shims for the gear case. φ14×φ8mm Ball Bearing (yokomo BB-1480-2), φ10×φ5mm Ball Bearing (yokomo BB-105-2) φ10×φ15mm Ball Bearing (yokomo BB-1510) Drive gear shim (yokomo ZC-S80B) These bearings will fit Drift package designed Gear housings, Not certain on DPM housing. Wrap up sells a open Diff housing, Overdose sells the Drift package gear housing which will work, or stock yokomo ones will work as well. Sorry for the bad news.

Thanks for the information.

So it looks like I purchased a lot of parts that I can't use!

So should I just purchase the Kokomo Drift package Type C?