Forums

LET THE VOTING BEGIN!

Another month down! Time for the September 2014 RC Drift Body of The Month Contest!!

We will accept the first 10 entries!

***BoTM RULES*** YOU MUST READ THIS BEFORE ENTERING!!!

• ** You must have 50 posts to enter! **
  
• 1/10 Scale Only! No Off The Shelf Painted Bodies!
  
• No touring car bodies e.g Protoform, etc...
  
• No comments, only entries please!
  
• First 10 entries will be accepted
  
• Two picture maximum
  
• Winners of previous month are ineligible
  
• DriftMission staff/vendors/sponsors may not enter * UNLESS 48 hours before cut off and 10 entries have not been received.
  

Both are the same.

The Pandora 180SX2X project.



Lights are servo operated.

Fall-mode Zenki (EASY MADE CREW)

Yokomo RX-7 FC3S with Mikuni Factory Advan ONI rims.

#STANCED with -5 degrees of camber.

Thanks goes to my man Ando-San at Team Tetsujin for importing these for me.

Tamiya Subaru WRX 190mm

78 parma el camino

3 stage paint(purple base, silver undercoat and copper inside body)

full led light system with hazards, high/low beams,turns(front and back), reverse, brake/tails

hpi vintage 5 spoke 26mm/31mm combo

aluminum drift wing

full interior with "redneck security"(baby gator),chain steering wheel and custom covered seats/dash

Here is my contribution for the BOTM september, its an Overdose Mark X Weld Streetstyle.

On this link more info and specs about the build:

http://forum.driftmission.com/Thread-od-...eetversion

My entry for Body of the Month

Nissan Silvia S15 "I Love Silvia"