DriftMission RC Drift Forums - Your Home for RC Drifting!

Full Version: Mr4TC SSG RWD
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Picked up a MR4TC SSG.


[Image: 20160709_001313.jpg~original][Image: 20160709_001350.jpg~original]
[Image: 20160709_001246.jpg~original]

Some goodies I got from our local track. 
WUN VX-DOCK SLIDE STEERING
WUN Upper and Lower ARMS
WUN LONG SERVO HORN
YOKOMO DPR MOTOR MOUNT

http://www.vertexrc-usa.com/ <--- Check them out for your Yokomo needs.

[Image: 20160709_001500.jpg~original]

To be continued....
That looks like it is going to be a pretty fun conversion/refresh. Are you planning on upgrading your front steering knuckles as well?

-Vic
(07-09-2016, 10:28 AM)DriftGundam Wrote: [ -> ]That looks like it is going to be a pretty fun conversion/refresh. Are you planning on upgrading your front steering knuckles as well?

-Vic

Yes. I have the Yokomo low scrub knuckles on my tub chassis that I will be switching over. I also went with the Team Suzuki motor mount, mounted in the middle position. Will post more pics after I get off work.
Got a bluebird servo. BMS 661 DMG + HS
[Image: 20160709_005521.jpg~original]


Heres the Wrap Up Next slide rack installed. Couldn't use the Top Brace with this installed.

[Image: 20160709_020242.jpg~original][Image: 20160709_020254.jpg~original][Image: 20160709_020312.jpg~original]

[/url]
Full Lock Right and Left.


[Image: 20160710_111831.jpg~original][Image: 20160710_111848.jpg~original]


Team Suzuki Motor mount. The Mount didn't actually line up with the holes so I only used the 2 that did line up.

[url=http://s1197.photobucket.com/user/1905rep/media/20160710_111757.jpg.html][Image: 20160710_111757.jpg~original]

Had to shave down the axle cups to get more angle.

[Image: 20160715_185921.jpg~original]

Just waiting on the Onisiki Gyro then I can start the tuning.
I wouldn't worry too much about only two holes from the Yokomo motor lining up with the TS motor mount slots. From my experience, if two holes that are diagonal from one another line up, you should be fine.

Also, one of your tags didn't work so an image isn't showing up.

-Vic