Here is what I did: one 27T and a 15T from my old HPI sprint.
Simply using the slight natural tension from these pulleys, allows them to remain in place and thus reducing the cost of having to buy that 20$ Aluminum Rear Bulkhead Bearing Housing Ver. 2.
This way the belt is super responsive and doesn't skip at all.
![[Image: 9o1t.jpg]](http://imageshack.com/a/img835/471/9o1t.jpg)
![[Image: d1x4.jpg]](http://imageshack.com/a/img18/5301/d1x4.jpg)
![[Image: 0gq3.jpg]](http://imageshack.com/a/img513/8932/0gq3.jpg)
![[Image: 2eoziap.jpg]](http://i41.tinypic.com/2eoziap.jpg)
(This post was last modified: 01-22-2014, 02:28 PM by yersinia.)
Simply using the slight natural tension from these pulleys, allows them to remain in place and thus reducing the cost of having to buy that 20$ Aluminum Rear Bulkhead Bearing Housing Ver. 2.
This way the belt is super responsive and doesn't skip at all.