(01-17-2013, 11:27 AM)Cloaked Wrote: Hi All
Been speaking to pickled on rctech.com but figured that this site was probably a better place to hang out for the Sakura D3
Just ordered my D3 CS yesterday, first drift car (first on road car!) Ordered a Tamiya 86 shell to make her look pretty.
Also ordered
1 x 3Racing Aluminum Front Bulkhead For Sakura D3 #SAK-D315/PK
1 x 3Racing Low Friction Front Belt 519 For Sakura D3 #SAK-D116
1 x 3Racing Low Friction Front Belt 183 For Sakura D3 #SAK-D115
1 x 3Racing Low Friction Front Belt 138 For Sakura D3 #SAK-D114
1 x 3Racing Aluminum One Way Tube For Sakura D3 #SAK-D324/PK
1 x 3Racing SSK Driveshaft For Sakura XI/Sakura FF/Sakura Zero #SAK-X27
1 x SPICE (#SPA-712) Camber Drift Tire Pull Type (Soft)
1 x SPICE (#SPA-065) GramLights 57D OFFSET 6 (White)
1 x SPICE (#SPA-067) GramLights 57D OFFSET 6 (Orange)
1 x 3Racing Spring Set For #M03M-13/LB/V2 #M03M-13/V2/OP
Anything else glaringly obvious I should order? pickled mentioned picking up some 1mm & 0.5mm m3 washers so they are already on the list. I will also be mainly running on smooth/polished concrete, massive underground parking garage for my apartment block, so any advice one wheel/tyre and shock oil/spring choice is appreciated.
Slowly reading through this thread.
Cheers for all the info.- Will
I think those springs will be too short? I'd get the blue SAK-D329 and green SAK-D326 from 3racing.com also try and get some Xpress (#XPA-BN4812) 4.8/12 Ball End and Yeah Racing (#BN-0009BK) 4.8mm Delrin Ball End Size 15.00mm these are what I got to replace the stock ends as they are open ball ends