RWD conversion questions

1 Replies, 1575 Views

Not  sure if you had any luck converting you Zero S. I have a clone version that I was thinking of making a RWD conversion. So far it is a spool in the rear, removed the front diff and belt. Remove the "dogbone" in the Universals drive shaft in the front. 

Thought able grinding the C Hubs or doing the C Hub delete but didn't have a spare in my box so I modded the front knuckles instead. Used a rotary tool to cut and grind out quite a bit of material. Got some improvements in steering angle but it seems like the inside wheel will always get a lot more steering angle than the outside wheel. Would this be a problem? 
   

I will also need to make a new top deck or grind it away to clear the line from the servo..... but if I am going down that route I was thinking if I should relocate the servo and go direct from servo to knuckles? 

Don't want to drill holes into the chassis because this clone came with the carbon chassis.

Messages In This Thread
RWD conversion questions - by AmirF35 - 11-15-2016, 09:09 AM
RE: RWD conversion questions - by jcr - 01-11-2017, 06:10 AM



Users browsing this thread: 1 Guest(s)