Sakura D4 chassis problems, front higher than rear

5 Replies, 2552 Views

I have a new chassis build. But I get one problem, the front is higher than rear, but I can't find the reason. I checked the manual, all parts are set correctly. But why is this so?

   
You can adjust damper height. Also check your front spring and rear spring. You might have in reversed.

Sent from my EML-L29 using Tapatalk
Team Magic - E4D(4) RWD - Sakura D4 RWD
Do you have all the electronics fitted?
More content at:
[Image: %25C5%258Ckami%2BDrift_banner.jpg]
(09-05-2018, 09:14 PM)MrAkhtar86 Wrote: Do you have all the electronics fitted?

Yes.
Well, Actually, I drive Honda dulux because it gave me pleasure of a luxury bike and drive pretty well. By the way click here to get more ideas about topic and much more. I like spending time on your forum to describe my car. Thanks
(This post was last modified: 02-25-2019, 07:49 AM by Pualsmith.)
2 years later...

I guess I'm late but there's a few adjustments on the D4 chassis that can cause this.  The inner suspension blocks have metal plates underneath them to adjust roll center, are there any on the rear?  Also each corner on the lower arm has droop screws, perhaps they're in further on the rear compared to the front?



Users browsing this thread: 1 Guest(s)