Forums

Full Version: mp3ranger sprint 2 drift setup
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
RC Drift Chassis Information
Manufacturer: HPI
Model: Sprint 2 Drift
Track Surface: cement
Tires: HPI a-type drift
Motor and ESC: 15t + hpi SC-15WP
Servo: Airtronics 94362

Chassis Settings
Front Setup
Camber (Degrees) (Positive is out, Negative is in): -2
Toe (Degrees) (Specify Toe in or out): 0
Caster (Degrees):6
Kick-up (mm): stock
Sway Bar (yes/no): no
Ride Height (mm): 6mm
Springs (indicate type, length, hardness, etc): 13x25x1.7mm 7 COILS
Damper Oil (indicate weight or #): losi 20wt
Upper Damper Position (Lower # indicates inner most position): center hole
Lower Damper Position (Lower # indicates inner most position): inter hole
Other (Weights, Mods, etc): 1.5oz of lead weight on the front bumper. One-way diff , reddrilled the ackerman locations

Rear Setup
Camber (Degrees) (Positive is out, Negative is in): -2
Toe (Degrees) (Specify Toe in or out): 3
Caster (Degrees):
Kick-up (mm):
Sway Bar (yes/no):no
Ride Height (mm):6
Springs (indicate type, length, hardness, etc): 13x25x1.7mm 7 COILS
Damper Oil (indicate weight or #): losi 20wt
Upper Damper Position (Lower # indicates inner most position): 2nd hole in
Lower Damper Position (Lower # indicates inner most position): other hole
Other (Weights, Mods, etc): install a locked balldiff to cut down weight

Drivetrain (Optional)
Front Belt (mm or teeth):58T
Rear Belt (mm or teeth):169T
Front Pulley (teeth and differential type): 32T
Front Center Pulley (teeth and differential type): 15T
Rear Center Pulley (teeth and differential type): 15T
Rear Pulley (teeth and differential type): 32T

Gearing
Spur (teeth and pitch):90
Pinion (teeth and pitch):23
How are you liking your sprint? Have you thought about moving to CS?
How did you adjust your ride height I'm having problem with that bit. People the droop screws but that doesn't lower it.


Sent from my iPhone using Tapatalk