Forums

yep they tension the belt use 1mm on the  front  screws and 0.5mm on the rear screws. I also have both one ways but not a Zero S? If you are only going FWD then you can put the front pulley in any position so yes it should work fine

(01-08-2013, 07:58 AM)pickled Wrote: [ -> ]yep they tension the belt use 1mm on the  front  screws and 0.5mm on the rear screws. I also have both one ways but not a Zero S? If you are only going FWD then you can put the front pulley in any position so yes it should work fine

wouldn't you get more tension on the belt if you only raised the rear? because raising both up, in the end the center belt is only getting that extra .5mm? I got the one way as well for it

Sorry I meant under the rear pulley mount not the deck it's self! by tilting the pulley mount backwards slightly the centre belt gets a little more tension

@Dorvack. OMG your chassis! I'm in love with that. you got the right idea man. I dont like the idea of fastening a block that is supposed to sit flat on washers of different sizes, especially since it is made out of plastic. I'd would REALLY like to know where i can buy the parts you used to make yours. I love it. I dont need the threaded sides for the in bound coils though. Just those tensioner blocks, idle pulley, bearings and the shaft/spacer combo. I would really appreciate that. I want to copy your swagger!

(01-10-2013, 01:31 AM)Dorvack Wrote: [ -> ]So just a parts list for the belt tensioner and mount?

Dorvack.

Yes please! I don't feel like dicking around and making something. I'm going to run my team tetsujin 519 for the center belt. Maybe it will be a bit tighter right off the bat?

Thought I'd post a pic of my steering angle with Square R31 CVD's installed in my MST knuckles

Yeah that actually helps a lot. I obviously won't be able to make the same exact thing but it points me in the right direction!

I actually might just go with the washers on top of the deck under the pulley mounts. But I don't want to stress the plastic threads at all so we'll see. Any other tensioning ideas? Maybe an idle gear pushing up in the tooth side of the belt?

(01-10-2013, 01:28 PM)pickled Wrote: [ -> ]Thought I'd post a pic of my steering angle with Square R31 CVD's installed in my MST knuckles

Have you got a build thread for this setup? cheers

---

(01-12-2013, 06:23 AM)WillG Wrote: [ -> ]I actually might just go with the washers on top of the deck under the pulley mounts. But I don't want to stress the plastic threads at all so we'll see. Any other tensioning ideas? Maybe an idle gear pushing up in the tooth side of the belt?

---

(01-15-2013, 06:19 AM)DriftStright Wrote: [ -> ]

(01-10-2013, 01:28 PM)pickled Wrote: [ -> ]Thought I'd post a pic of my steering angle with Square R31 CVD's installed in my MST knuckles

Have you got a build thread for this setup? cheers

---

(01-12-2013, 06:23 AM)WillG Wrote: [ -> ]I actually might just go with the washers on top of the deck under the pulley mounts. But I don't want to stress the plastic threads at all so we'll see. Any other tensioning ideas? Maybe an idle gear pushing up in the tooth side of the belt?

Here's what Iv come up with seems ta be secure, Probblley abit overkill pulley tensionor though! lol
The belt should be placed on the underside of the pulley, was just exspermenting lol
Made up of HSP, TA-03, parts